Soda flakes are still quite important at the level of the reaction vessel,because various materials may be involved in the reactor during our daily use.However,sometimes when using the reactor,some oils and fats that are not easy to clean may be added,so soda flakes need to be used for cleaning.
1.Firstly,it is necessary to clean most of the residual materials in the reaction kettle with clean water.If any materials that cannot be cleaned are found after cleaning,manual cleaning is required.You can choose to use a brush or other methods for cleaning.

2.Then,it is necessary to add clean water to the appropriate position in the reaction kettle,and then add a suitable amount of caustic soda or hydrochloric acid.Slowly heat the equipment to 80 degrees Celsius and continue stirring for 30 minutes.Then,open the discharge valve and clean the material pipeline through the material circulation pump.
3.Then rinse it with a large amount of clean water until the pH value inside the device is neutral.Also,the valves for feeding and discharging need to be cleaned repeatedly.
4.Generally,after producing a batch of products,it is necessary to clean the interior of the equipment with caustic soda,and if it is not used within a day after cleaning,it also needs to be cleaned again.
Through the introduction of the editor,we learned that using caustic soda to clean the reaction kettle is very effective,but we also need to control the concentration used when cleaning.Usually,it is necessary to obtain sufficient dissolution in water before cleaning.